Trouble Shooting Help For Swimming Pool Pumps

Here are some great tips for trouble shooting problems you may encounter with swimming pool pumps. If your pump will not power on it might be because of water damage. Use a volt meter to determine if the pump is getting sufficient voltage. Your pump needs to be placed in an area that has good drainage. Flooding from rain can damage your pump.

Your pump’s thermal overload may be the cause of your pump heating up and then shutting down. This may be caused by debris blocking the air intake vents. The pump’s motor will over heat and then the thermal overload will turn the pump off if the vents are clogged. If you have a poor connection or an undersized wire, not enough electrical power will reach your pump. Have an electrician inspect your pump and repair it if necessary. If your area is experiencing high temperatures, your power company may be having a power shortage. Turn your pump off until the temperatures is lower.

Noisy pumps can be caused by several reasons. If the pump is not level, vibrations from the base of the pump will cause noise. You can correct this by packing some padding around the base of the pump. A seal with a leak can damage bearings and then the bearings will make noise. Pipes and tubes that are too small for the pump can also make noise. Make sure the piping size is appropriate for your particular pump.

If you experience a sharp increase in your electric bill, check the timing clock or automated control to see if it is set correctly. Make sure your circulation time is set appropriately for the size of your pool. Keep in mind that electrical rates have increased greatly.

Air leaks can cause your pump not to fill with water. Check your suction line to make sure it is not obstructed. Inspect the motor shaft to verify that the impeller has not come off.

Pump covers will extend your pump motor life. However, they are not required. If you do use a pump cover, make sure you do not obstruct the cooling vents. If the cooling vents are blocked, your pump will not have good air circulation and can over heat and then shut down.

If water is not flowing when the motor is running, check for a blocked line or a dirty filter. A valve that is shut off can also cause this problem. A clogged impeller might be the cause as well. Clean the impeller if necessary. Air bubbles flowing into the pool may indicate that there is a leak on the pump. Check the level of water in the pool. Low water level will cause water and air to mix into the skimmer.

While the ordinary person can inspect many seals, filters, and other parts on a pump, it is probably a good idea to call an authorized repair person who is experienced working on swimming pool pumps. Always have a licensed electrician for electrical repairs. Electrocution can be fatal. Check your pump’s warranty. While many maintenance routines can be done by a non-expert, it is best to call a qualified expert for serious repairs. Hopefully, these tips will help you enjoy your swimming pool for many years to come.

swimming pool filter pump Pool covers are designed to protect your pool and the water – they aren?t made for safety. “But Sir, I burn easily and I have sensitive skin. Your swimming pool is always your favorite place to relax and recreate.

Related Blogs

Leave a Reply