Combining The Food Disposal With Your Dishwasher

It is not a difficult job to fit a garbage disposal unit in kitchen sink. There is no doubt that assembling its parts and checking it for no leaks is a time consuming exercise. And if we have a dishwasher, it will enhance the labor and time taken because dishwasher is emptied into the waste pipe. But with the fitting of the garbage disposal unit, the dishwasher is emptied in the garbage disposal.

These are easily connected to dishwasher drain lines so that the waste food drains into the disposal as well. Here is the stepwise procedure to attach the garbage disposal with the dishwasher.

To begin this process we shall first of all clean the bottom of the sink cabinet and keep a bucket beneath the sink. Using a pipe wrench, loosen the pipe and remove it. Any water in the pipe may be disposed in the bucket. Remove the drain pipe by unscrewing the long screws that joins the sink and the drain pipe.

Use a small putty knife to trim away the old plumber’s putty that helped seal the drain inside the sink, and lift the drain pipe out of the sink.

We shall connect the garbage disposal unit to the sink. Apply a coat of plumber’s putty of about quarter an inch around the sink hole and place the sink mounting assembly and the flange piece through the hole and fit it into the cabinet underneath. The drain pipe should be pressed on to the putty so that it can give a sealing effect. The ring is to be tightened by hand so that it does not move from its position on the sink. Wipe out any excess putty pushed out by the tightening.

Align the disposer with the three mounting ears on the sink mounting assembly. Holding the disposer in place, turn the lower mounting ring until all three mounting ears are locked into the mounting assembly.

Bringing the mounting and the disposal in line, slightly turn the unit and it will tighten and get locked with a click sound. The wall drain pipe can then be connected with the unit and using the J-trap supplied by the manufacturer.

The disposal plug should then be pushed into the outlet below the sink and the reset button be pressed. This will set the disposal ready for use. Open the water tap of the sink and look for leaks. Make sure the power is switched on and the disposal is activated. Also, ensure that the unit turns in. The water should keep running during the is process otherwise the unit may damage.

Scott Rodgers is a fine writer who has been providing great guidance on plumbing works all over USA. His exemplary knowledge has, in fact, sparked significant rise in revenue for talented plumbers across the nation, from Lawrenceville Plumbers (Need one?click here!) to Belleair Beach Plumbers (Need one?click here!).

For Regular Garden Maintenance or Garden Cleanups in the Upper Highway area from Westville and Pinetown to Kloof, Hillcrest and Assagy call Matt on 0847125129, email him on matt@gardenbarber.co.za or visit http://gardenbarber.co.za/1662/why-you-should-use-a-garden-service-contractor/. Specialists at Maintaining and Servicing Gardens in the Upper Highway area, Hillcrest, Gillitts, Kloof and Waterfall

Leave a Reply